Rev 2 Board Layout Is Complete


Picture

I just finished the rev 2 board layout for the Serial-interface NVM Expansion Board with the added hardware to properly assert the CS lines in a mutually exclusive manner.  I was also able to slightly reduce the overall size to 1.0″ x 2.0″.  These will get submitted to OSH Park in the next day or two, or as soon as I have time to generate gerbers and carefully review them – a must unless you like spending your money on PCB’s that will only get used for wall art.  As I mentioned in a previous post, sample firmware development as begun and I hope to have this available soon to share.  I also have plans to repackage this board into an Arduino form factor once all functionality is proven out.  Stay tuned…

Here’s a larger picture.

Leave a comment

Your email address will not be published. Required fields are marked *